Code CR 2500 Manuel d'utilisateur télécharger pdf (Page 37)

C004386_07_CR2500_ User_Manual - 31

Save Settings

2.11.1 - Continuous Scan - Sleep Time Out

Scan one of the codes below to set the amount of time a cabled CR2500 will operate in continuous scan mode, without a

decode, before entering sleep mode:

Cabled - 2 hours (Default) Cabled - Always

Scan one of the codes below to set the amount of time an uncabled CR2500 will operate in continuous scan

mode before entering sleep mode:

Uncabled - 5 minutes (Default) Uncabled - 15 Minutes Uncabled - 30 Minutes

Note: This function is only recommended for short term use because of battery consumption.

2.11.2 - Continuous Scan - Trigger Delays

Scan the following codes to set delay time between scans:

0 Seconds (Default) 1 Second 3 Seconds

2.11.3 - Continuous Scan - Duplicate Scan Suppression

Scan the following codes to set the period of time during which duplicate codes are ignored:

0 Seconds (Default) 1 Second 3 Seconds

2.11 - Continuous Scan Settings

2.12 - Motion Detection Scan Settings

Scan the following codes to set the reader to read when it detects motion in its scanning zone:

Motion Detection On Motion Detection Off

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 61 62

Pas de commentaire

Code CR 2500 Manuel d'utilisateur Page 37