Code Reader 1200 Manuel d'installation télécharger pdf (Page 154)

TC1200 REFERENCE MANUAL

142

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:

1. Go to page 62 and scan

the ENTER/EXIT barcode.

2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as

suffix) by scanning the appropriate barcode in the section "Transmit Custom Label IDs"

on page 62.

Reference the figure below for Label ID positioning options.

3. Scan a barcode to select the symbology for which you wish to configure a custom Label

ID from the section "Custom Label Identifiers" starting on page 62.

Determine the desired character(s) (max 3) which will represent the Label ID for the

selected symbology.

5. Use the Chart in Appendix C to find the hex equivalent(s)

for the desired character(s).

6. Scan the hex equivalent characters

from the keypad in Appendix B that represent the

desired character string in step 4 above. If you wish to select an equal sign, the

corresponding hex number for the ‘=’ character is 3D. To enter this selection code, scan

the ‘3’ and ‘D’ barcodes from Appendix B.

NOTE

If you make a mistake before the last character, scan the CANCEL barcode

to abort and not save the entry string. You can then start again at the

beginning.

7. If less than the expected string of 3 characters are selected, scan the ENTER/EXIT

barcode to terminate the string.

8. Scan the ENTER/EXIT barcode once again to exit Programming Mode.

This completes the steps to configure a Label ID for a given symbology.

Figure 15 - Label ID Position Options

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 175 176

Pas de commentaire

Code Reader 1200 Manuel d'installation Page 154