Code Code Reader 1400 Guide de l'utilisateur télécharger pdf (Page 74)

5 - 2

you are programming. (See Primary/Alternate Data Formats on page

5-8 for further information.)

Step 3. Terminal Type

Refer to Terminal ID Table (page 5-4) and locate the Terminal ID

number for your PC. Scan three numeric bar codes on the inside back

cover to program the scanner for your terminal ID (you must enter 3

digits). For example, scan 0 0 3 for an AT wedge.

Note: The wildcard for all terminal types is 099.

Step 4. Code I.D.

In the Symbology Charts, beginning on page A-1, find the symbology to

which you want to apply the data format. Locate the Hex value for that

symbology and scan the 2 digit hex value from the Programming Chart

inside the back cover of this manual.

Note: If you are creating a data format for Batch Mode Quantity, use 35

for the Code I.D.

Step 5. Length

Specify what length (up to 9999 characters) of data will be acceptable

for this symbology. Scan the four digit data length from the

Programming Chart inside the back cover of this manual. (Note: 50

characters is entered as 0050. 9999 is a universal number, indicating

all lengths.)

Step 6. Editor Commands

Refer to Data Format Editor Commands (page 5-4). Scan the symbols

that represent the command you want to enter.

Step 7. Scan Save to save your data format, or Discard to exit without saving

your changes.

Enter Data Format

Save

Discard

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 215 216

Pas de commentaire

Code Code Reader 1400 Guide de l'utilisateur Page 74