Code Code Reader 1400 Guide de l'utilisateur télécharger pdf (Page 193)

11 - 3

• You need to program a suffix. Programming a suffix enables the scanner

to output the bar code data plus the key you need (such as “CR”) to enter

the data into your application. Refer to Prefix/Suffix Overview beginning

on page 4-1 for further information.

Does the scanner read the bar code incorrectly?

If the scanner reads a bar code, but the data is not displayed correctly on

the host screen:

• The scanner may not be programmed for the appropriate terminal

interface.

For example, you scan “12345” and the host displays “@es%.”

Reprogram the scanner with the correct Plug and Play bar code. See

Programming the Interface beginning on page 2-1.

• The scanner may not be programmed to output your bar code data

properly.

For example, you scan “12345” and the host displays “A12345B.”

Reprogram the scanner with the proper symbology selections. See

Chapter 6.

The scanner won’t read your bar code at all.

Scan the sample bar codes in the back of this manual. If the scanner

reads the sample bar codes, check that your bar code is readable.

Verify that your bar code symbology is enabled (see Chapter 6).

If the scanner still can’t read the sample bar codes, scan All Symbologies

(page 6-2).

If you aren’t sure what programming options have been set in the scanner,

or if you want the factory default settings restored, refer to Resetting the

Custom Defaults on page 1-7.

•

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 215 216

Pas de commentaire

Code Code Reader 1400 Guide de l'utilisateur Page 193