Code Code Reader 1000 Manuel d'utilisateur télécharger pdf (Page 15)

PROGRAMMING GUIDE

START

The START bar code places the reader into the program mode. After scanning

this label, the reader will emit three short BEEPS to indicate that it is in the

program mode.

EXIT (SAVE CHANGES)

Scan this bar code to EXIT the program mode and save all of the changes. After

scanning this label, the reader will BEEP twice, then delay approximately one

second, and emit three short BEEPS to indicate that it accepted the changes.

EXIT (IGNORE CHANGES)

Scan this bar code to EXIT the program mode and DISCARD all of the current

changes. The reader will use the settings that were in effect before entering the

program mode.

RESET ALL DEFAULTS

Scan this bar code to RESET all options to their DEFAULT settings.

0-9 BAR CODES

These bar codes are scanned to select various options and enter programmable

data into the reader.

NOTE: Scan option (9) to reset all of the options within

the current CATEGORY back to their defaults.

If the OPTION has an (ON/OFF) beside the description, scan the ON bar code

to turn ON the current option.

OFF

If the OPTION has an (ON/OFF) beside the description, scan the OFF bar code

to turn OFF the current option.

FULL ASCII CHART

The FULL ASCII CHART is located on the back of the SETUP MENU. This chart

contains the entire ASCII character set (128 characters). Use this chart to enter

PREAMBLE and POSTAMBLE character strings, or for a USER DEFINED

TERMINATION CHARACTER.

ADDITIONAL NOTES:

If the description beside the OPTION contains:

(ON/OFF) Then scan either an ON or OFF label to set the option.

(CHART) Then scan one or more characters from the Full ASCII Chart.

(0-9) Scan the desired character from the 0-9 labels.

(0.0-9.9) Scan two characters from the 0-9 labels to set the time from

0.0 to 9.9 seconds.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 53 54

Pas de commentaire

Code Code Reader 1000 Manuel d'utilisateur Page 15